20
ENGLISH
5
3. Place the Motor Housing on the top of the stand and thread the
Large Pivot Bolt (20) through the bracket and screw in the Small
Retaining Screw (8) and tighten (but do not over tighten).
4. Fit the Large Pivot Knob (7) onto the end of the Bolt (20) and
the Small Adjusting Knob (19).Hold the fan motor upright and
tighten the Large Pivot Knob (7) and the Small Adjusting Knob
(19).
OPERATING INSTRUCTIONS
1. Set the fan on a dry, level and sturdy surface.
2. Plug the fan into the mains.
3. Be sure the voltage of fan conformed to local power condition
before using it.
Oscillation,adjusting angle
1. Push down the oscillation knob to make the fan head oscillate,
and pull-up the oscillation knob to stop the fan head from
oscillating.
2. Loosen the adjusting angle knob, adjust the fan to the desired
angle, to secure tighten the adjusting angle knob.