EXTENDED
RETRACTED
...............4
2 x 10 mm screw
TOP VIEW
X
To retract gear
To retract gear
Retract servo
Retract push rod
Retract push rod
Linkage Stopper
7-Main Wing
Retract push rod: Cut off excess,
If rod interfer, bend “C” linkage rod.
8-Engine mount
4x30 mm screw
..........4
..........4
..........4
In case of 4T engine.
4.2mm
!
Align the mark on both mounts
with the mark on the fuselage
1.5mm
A B
!
CA
L/R
Assemble left and right
sides the same way.
X
Drill holes using the stated
size of drill
(in this case 1.5 mm Ø)
Use epoxy glue
Take particular care here
Hatched-in areas:
remove covering
film carefully
Not included.
These parts must be
purchased separately
Check during assembly that these
parts move freely, without binding
Apply cyano glue
