10
5.6 REPLACING THE CONDENSER
NOTE:
Before replacing any component of the refrigeration system, make sure to read the instructions “Service
Precautions for R600A System” or “Service Precautions for R134a System”.
1. Disconnect the unit from the power source.
2. Clean and then solder the inlet and the outlet tube from the old condenser.
3. With assistance, tilt the cabinet side and remove the screws 2 which secure the condenser to
the cabinet bottom.
4. Install the new replacement condenser to the cabinet by screws.
5. Clean then connect the hot pipe to the outlet tubing. Clean again and connect the inlet tubing
of the condenser to the spiral pipe.
6. Solder all joints. Silver solder and proper flux should be used on copper to steel or steel to steel joints.
Excess flux should be wiped off all tubing.
1
2
3
4
