INSTALLING THE STAINLESS STEEL HANDLE
This beverage cooler includes a stainless steel handle that is not required to operate this unit. To install
the handle please follow the below instructions:
①
Pull away the door gasket in the area where the handle is to
be installed. You can see two designated holes for handle
installation. The gasket is easily displaced by hand, no tools
are necessary.
②
Install the handle tightly as shown below with the two
screws, lock washers and flat washers provided. (DO NOT
over tighten as this will cause damage to the handle assembly
and stainless steel surface of the glass door).
③
Replace the door gasket to its original position.
INSTALLING THE CHARCOAL FILTER
To install the charcoal filter, please follow the below instructions:
•
Place the carbon filter on top the wooden shelf.
•
The back of the filter has a 3M glue tape which you can
affix to the shelf or the inside of the unit.
OPERATING YOUR BEVERAGE COOLER
The beverage cooler should be placed in a position where the ambient temperature is between 5-38°C/41-
100°F. Humidity level is between 45-90%. If the position is above or below this range, the performance of the
unit may be affected. For example, placing your unit in extreme cold or hot conditions may cause interior
temperature to fluctuate.
NOTE:
l
When you use the beverage cooler for the first time or restart the beverage cooler after having been
shut off for a long time, there could be a few degrees variance between the temperature you select and the
one indicated on the LED readout. This is normal and it is due to the length of the activation time. Once the
beverage cooler is running for a few hours everything will be back to normal.
l
If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting the unit.
If you attempt to restart before this time delay, the beverage will not start.
