SETTING THE TEMPERATURE CONTROL
You can select temperature display setting from Fahrenheit to Celsius degree by touching the °C/°F
Selector mark. Fahrenheit or Celsius degrees indicator will appear in blue color in the temperature
display window. You can set the temperature as you desire by touching the UP and DOWN marks.
When you touch the two marks for the first time, the LED readout will show the original temperature
set previously.
l
The temperature that you desire to set will increase 1°C or 1°F if you touch the UP mark once,
on the contrary the temperature will decrease 1°C or 1°F if you touch the DOWN mark once.
l
Temperature range: 1- 18 °C/34-64°F
l
The temperature inside the unit will be appeared in blue color in the display window.
Light switches are under the control panel to control the lights turn on/off:
①
LED light
②
Orange backlight
③
Blue backlight
When turn on Blue/Orange backlight at the same time, the color varies by optical action.
Don’t turn on the backlight synchronously for a long time, otherwise that cause raising the consumption.
SHELVES
l
To prevent damaging the door gasket, make sure the door is fully open when pulling shelves out of
the rail compartment.
l
For easy access to the bottles stored, pull the shelves out approximately 90%.
DOOR LOCK
The beverage cooler comes with a lock and key combination. The keys are located inside the plastic bag containing
the Owner’s Manual. To unlock the door, insert the key into the lock and turn it counter-clockwise. To lock the door,
insert the key and turn it clockwise, ensuring that the metal pin is fully engaged.
DEFROSTING
The beverage cooler defrosts automatically. The evaporator behind the rear wall of the unit automatically defrosts and
the condensate collects in the drainage channel behind the rear wall of the unit, and flows through the drainage hole
into the drip tray by the compressor, where it evaporates.
