Installing the Casters
z
Remove the 4 castors from one of the boxes inside the unit. Install the two castors
with metal bracket at the front designated positions of the cabinet base and the
additional two castors at the rear designated positions (Four screw holes are pre-
supplied).
•
In order to release or lock the brake, follow the below guide.
Step d own to Br ake
Step on to Release Brake
Kegerator Assembly
•
Place the gasket over the hole opening on the worktop.
•
Pass both the wing nut and the beer tube through the hole on the worktop until the
beer tap is resting on top of the cabinet.
•
Revolve the beer tap clockwise and secure it.
•
Spanner faucet wrench provided for either removing or tightening connection.
•
Attach the black plastic lever (pull handle) provided on the top of the faucet tightening
it by hand clockwise until the end, holding in the silver snug underneath so it does not
move. (See Figure 1)
•
If there is still a small drip from the faucet, you
may have tightened the plastic lever too much and
may need to unscrew silver snug counter-clockwise
(as shown in Figure 2) one turn. That should
correct the problem if exists.
Figure 1 Figure 2
8
W W W . V I N O T E M P . C O M
