13
1 7 6 2 1 S o u t h S u s a n a R o a d , R a n c h o D o m i n g u e z , C a l i f o r n i a 9 0 2 2 1
i n f o @ v i n o t e m p . c o m
PROBLEMS WITH YOUR APPLIANCE
You can solve many common cooler problems easily, saving you the cost of a possible
service call. Try the following suggestions to see if you can solve the problem before
contacting Vinotemp at info@vinotemp.com.
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
Cooler does not
operate
Not plugged in.
Using wrong voltage.
The circuit breaker tripped or there is a blown fuse.
Cooler is not cold
enough
Check the temperature control setting; external
environment may require a higher setting.
The door is opened too often.
The door is not closed completely.
The door seal does not seal properly.
The wine cellar does not have the correct clearances
to operate efficiently and safely.
Turns on and off
frequently
The room temperature is hotter than normal.
A large amount of contents has been added to the
appliance.
The door is opened too often.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
Vibrations
Check to see that the wine cellar is level.
Cooler seems
to make too much
noise
The rattling noise may come from the flow of the
refrigerant, which is normal.
As each cycle ends, you may hear gurgling sounds
caused by the flow of refrigerant in your unit.
Contraction and expansion of the inside walls may
cause popping and crackling noises.
The appliance is not level.
Door will not close
properly
The wine cellar is not level.
The doors were not properly installed.
The seal is weak.
The shelves are out of position.
The light does not
work
Not plugged in.
The circuit breaker tripped or a blown fuse.
The light switch is “OFF”.
