48
Counter:
No Counter
Preparing...
Please Wait
OK: 0 NG: 0 NB: 0
Input Bin > Drive01
Processing...
Please Wait
OK: 3 NG: 0 NB: 0
Input Bin > Drive02
OK: 0 NG: 0 NB: 0
Input Bin > Drive02
Follow the instructions shown in
“Setting Counters”
on page 17 to continue.
Once the counter has been set, press the
ENT/Enter
button to confirm. You
will then see the
Preparing
screen:
After a short interval, the robotic loader will pick the top disc (the Maser Disc)
from the input spindle and place it into one of the drives. As this is
happening, you will see a screen similar to below:
This information screen shows what is happening. In this case, the loader
has taken a disc from the input spindle and is placing it into Drive 1.
The loader will perform the loading process which will transfer the content of your master disc into the
reserved partition of the hard drive.
Upon the successful loading process, the system will drop the Master Disc
onto the output spindle. It will then pick up the blank discs from the input
spindle and place those into drives until either all of the drives are full, or the
count that you loaded into the counter is reached.
It takes a few seconds for the autoloader to recognize all the discs.
After two or three seconds of processing time, one of the following
Copy Progress
screens will appear.
Counter Specified
No Counter Specified
Copying... H4012MB
0/21 12% 481MB
or:
Copying... H4012MB
0 12% 481MB
“H” indicates the source of the job
resides in the Hard Drive.
“4012MB” indicates the capacity of
the master disc.
“12%”/”481MB” indicates the
current progress of the duplication.
“0/21” indicates you have a project
size of 21 copies and you have
made 0 copies so far.
“H” indicates the source of the job
resides in the Hard Drive.
“4012MB” indicates the capacity
of the master disc.
“12%”/”481MB” indicates the
current progress of the
duplication.
“0” indicates you have made 0
copies so far.
Note:
It is normal to see the progress indicator stay at 0%-10% and 100% for approximately 30
seconds for CD duplication and up to one minute for DVD/Blu-Ray Disc duplication. That is caused
by the initializing and finalizing stages.
Once the duplication run is completed, the loader will remove the finished
disc from a drive and place the successful copy on the Output Spindle or if it
is a bad/NG copy, place it on the reject area. This will repeat for each drive.
The loader will then pick up another blank disc and load it into the drive. This is then repeated for each drive.
The copying process will continue until you either run out of blank discs or
until the count that you loaded into the counter is reached.
If you run out of blank discs and the job is not complete, the autoloader will give you an opportunity to fill the
spindle:
Important:
When you add discs to the input spindle, be sure to remove your finished discs from the
Output Spindle.
OK: 3 NG: 0 NB: 0
Drive01 -> Output Bin
Summary of Contents for ROBOTIC AUTOLOADER 3.6.0
Page 1: ...User s Manual v3 6 0...
