7
901136 REV A 10/3/11, INST 64-66 CHEV P-UP wo AC w/ STD EVAP KIT PG 7 OF 24
REMOVE GLOVE BOX DOOR (RETAIN) AND GLOVE BOX (DISCARD).
DISCONNECT ALL WIRES AND CABLES FROM CONTROL PANEL .
REMOVE CONTROL PANEL (RETAIN).
REMOVE OEM DUCT HOSE FROM DEFROST DUCTS (SEE FIGURE 2 BELOW.)
OEM HEATER ASSEMBLY.
REMOVE PASSENGER SIDE FRESH AIR DOOR ASM (DISCARD) (RETAIN SCREWS) (SEE FIGURE 2a).
INSTALL PASSENGER SIDE FRESH AIR COVER USING OEM SCREWS AS SHOWN IN FIGURE 2b BELOW.
INSTALL HOSE ADAPTERS ON OEM DEFROST DUCTS USING (2) S-CLIPS AS SHOWN IN FIGURE 2 BELOW.
PASSENGER COMPARTMENT
CONDENSER ASSEMBLY & INSTALLATION
REFER TO SEPARATE INSTRUCTIONS INCLUDED WITH THE CONDENSER KIT TO INSTALL THE CONDENSER.
BINARY SWITCH INSTALLATION (REFER TO CONDENSER INSTRUCTIONS)
REFER TO SEPARATE INSTRUCTIONS INCLUDED WITH THE BRACKET KIT TO INSTALL THE COMPRESSOR
AND BRACKET.
COMPRESSOR & BRACKETS
REMOVE THE FOLLOWING:
FIGURE 2
OEM HEATER
ASSEMBLY
CONTROL
PANEL
BACKSIDE OF
PASSENGER SIDE
FRESH AIR COVER
OEM DUCT
HOSE
HOSE
ADAPTER
49168-VCI
(2) S-CLIPS
65980-VUE
GLOVE BOX
&
DOOR
FIGURE 2a
FIGURE 2b
PASSENGER SIDE
FRESH AIR
DOOR ASM
PASSENGER SIDE
FRESH AIR
COVER
644095
(6) OEM
SCREWS
SILICONE
HOSE
ADAPTER
49168-VCI
(2) S-CLIPS
65980-VUE