1964 IMPALA
w/ AC
11
904064 REV A 7/22/08, 1964 IMPALA w/ AC GEN IV EVAP INSTR PG 10 OF 25
FIGURE 8
EVAP FRONT
BRKT
643163
(2) 18287-VUB
1/4-20 x ½”
HEX BOLT
(3) 18290-VUB
1/4-20 x 1”
HEX BOLT
(3) 189125-MUR
1/4 PUSH NUT
BOLT FASTENER
FIGURE 8a
18287-VUB
(2) 1/4-20 x ½”
HEX BOLT
18287-VUB
(2) 1/4-20 x ½”
HEX BOLT
EVAP REAR
BRKT
643164
INSTALL (3) 1/4-20 x 1” HEX BOLT AND 1/4” PUSH-ON NUT ON EVAP REAR BRKT AS SHOWN IN FIGURE 8a BELOW.
INSTALL EVAPORATOR FRONT & REAR MOUNTING BRACKETS ON EVAPORATOR USING (6)1/4-20 x 1/2” HEX BOLTS
AND TIGHTEN AS SHOWN IN FIGURE 8 & 8a BELOW.
INSTALL (2) A/C HARDLINES WITH PROPERLY
ON A WORK BENCH INSTALL (2) HEATER LINE WITH PROPERLY LUBRICATED O-RINGS. (SEE FIGURE 13 PAGE 14, AND
FIGURE 19 PAGE 19.)
LUBRICATED O-RINGS. (SEE FIGURE 13 PAGE 14, AND FIGURE 19 PAGE 19.)
EVAPORATOR INSTALLATION
