Contents
1. Before starting the appliance
2. How to use the appliance
3. Maintenance
4. Has the appliance stopped working?
5. Safety
6. Technical
data
7. Installation
8. Change of hinge side
9. Lighting
fixture
1. BEFORE STARTING THE APPLIANCE
Check that the cabinet is undamaged. Please report
any damage
immediately
to your dealer. Wash the
cabinet and inner lining with a mild unscented
detergent and wipe it dry. Do not use abrasive
scouring powder, steel wool or similar. Connection to
the electricity supply. See head 7 and 8.
2. HOW TO USE THE APPLIANCE
Operating panel (see fig. (5) page (4)
1. Thermostat
Knob
2. Indicator for the connection to the electricity
supply (green).
3. Switch for light
The thermostat knob is adjustable from 0 (stop) to 7
(coldest). Find the position of the thermostat which
gives you the desired temperature. Start at position 4.
It should give you a temperature of around 14º.
DEFROSTING
The evaporator is automatically defrosted.
The defrost water is led to a tray on top of the
compressor where it evaporates
3. MAINTENANCE
Only use an unscented detergent when clearing the
cabinet inside.
You may remove the top panel and wash it when
cleaning the cabinet inside.
Switch off the appliance and pull out the plug when
cleaning the cabinet.
The skirting board at the bottom, can be removed to
facilitate a vacuum-cleaning of the floor. See fig. (1)
page (5). To remove it, unscrew the two screws on the
front and pull slightly downward the board before
pulling it to you.
To make the cooling system work at its optimum it is
necessary from time to time to clean the wire
condenser and the compressor at the back of the
cabinet by means of a brush or vacuum cleaner.
Remember to clean the drain, making sure it is never
obturated by a piece of label or else.
IMPORTANT
In case of damage to the power cord it must be
replaced by a power cord of corresponding type,
available from the manufacturer or his service
representative.
4. HAS THE APPLIANCE STOPPED
WORKING?
Before calling a repairman, check that
!
The plug is properly plugged into the socket.
!
The fuse is intact.
!
The power has not been cut off.
!
All controls are correctly set.
!
Switch off the cabinet for 15 minutes (for instance
at the thermostat). Switch it on again and after 5
minutes check whether frost has formed on the
evaporator.
!
Do not open the cabinet when unnecessary.
5. SAFETY
Do not
store explosive substances in the refrigerator
section, such as gas, cigarette lighters, petrol, ether or
similar. Scrapped cabinets may become dangerous to
children at play. Therefore, remove the doors or place
the scrapped cabinet in such a way that children
cannot enter it.
Never store liquids with carbon dioxide.
6. TECHNICAL
DATA
This appliance meets the provisions of the following
d i r e c t i v e s : 8 9 / 3 3 6 / E E C ( e l e c t r o - m a g n e t i c
compatibility), 73/23/EEC (electrical equipment
designed for use within certain voltage limits) as
amended.
Household appliances sold in the EU also meet
96/57/EEC (energy efficiency requirements) as
amended.
The rating plate, which is placed in side the appliance
(see fig. (6) page (4), provides various technical
information as well as type and serial numbers.
