7. INSTALLATION
See drawings-fig.1 page (5)-fig. (2a), (2b), (2c), (2d)
and (3) page (6).
Install the cabinet in a dry place so that it is not
exposed to direct sunlight or any other source of heat.
Place the cabinet in a level position. This is easily
achieved by adjusting the adjustable feet at the front
edge of the base. To do this, either ask somebody to
help you to tilt backward the cabinet, holding it in such
position that you can have access to the feet, or undo
the skirting board (see maintenance).
The cabinet may not rest against a wall on its hinged
side.(you need to open the door more than 90º to take
the shelves out)
When placing the cabinet on a carpet or on a wooden
floor you should adjust it once more after some time
as the cabinet might settle in soft foundations.
If you want to build the appliance into a cupboard you
must consider 3 factors:
1. There must be space above the appliance in
order to make the cooling system work
satisfactorily.-Fig. (2a) page (6).
2. the distance to the wall at the hinge side must be
of a sufficient size.-Fig (3) page (6) in order to
open the door more than 90º. (or the door frame
must be ouside, not flush with the wall.)
In addition, the wine cabinet may be built in or
positioned alongside another unit-fig. (3) page 6. In
such case, a 25mm gap must be left between the two
cabinets.
Any local installation rules for appliances of this kind
must be observed. During a storm the electricity
supply might be cut off. You should be aware of this
when installing the appliance in weekend cottages or
elsewhere where you would not immediately observe
that the power has been cut off. Construction and
details in the accessories are subject to alteration
without previous notice.
8. CHANGE OF HINGE SIDE
Follow the instructions below if you wish to install the
door hinges at the opposite side. (all our cabinets are
delivered right hinged).See the drawings on page (7).
- Open the door.
- Loosen the two little screws underneath the black
plastic cover and which holds the cover in place (do
not unscrew them completely since it would be very
difficult to screw them back.)
- Remove the plastic cover by pulling it out.
- Using the Stanley keys supplied with the cabinet,
unscrew the upper hinge.
- Remove the door.
- Unscrew the bottom hinge.
- Use the removed upper hinge as the new bottom
hinge. To do this, you will have to rotate the hinge
180º and to undo the pivot and the counter nut so that
you can replace the latter in the right position.
(upright).
- Rotate the glass door 180º and replace it on the
new bottom hinge.
- Install the new upper hinge. (ex right bottom hinge).
Make sure it is correctly positioned and the door seals
properly.
- Tighten all the nuts of the hinges (top and bottom).
- Replace the black plastic cover. (You will have to
remove a small piece of the panel from the cabinet,
located near the new left upper hinge in order to put
the cover completely in place. You will see easily what
to do when you will do it)
- Tighten the two little screws in order to fix the cover.
9. LIGHTING
FIXTURE
See the drawing on page (7).
1. Pull the screen to the left
2. Pull down the right side of the screen and take it
out.
• Remove the strip by pulling it out of the tracks along
the whole length of the profile.
• The fluorescent tube can be replaced.
To replace the screen, follow the same process but in
reverse order. The light switch can be replaced
without removing the screen.
DISPOSAL OF THE APPLIANCE
The appliance contains recyclable materials.
When disposing of the appliance, please contact
the technical administration or other appropriate
authority in your municipality. They can inform
you of the collection and recycling measures
used in the municipality.
