Vintec VWS035SBA-X, User Manual

INSTALLATION & STORAGE

Front View (

VWS048SCA-X

 )

Failing to comply with the above specifications could

result in WARRANTY void.

INSTALLATION  DRAWINGS FOR BUILT IN Wine Cellar :

(UNDERBENCH OR IN COLUMN)FRONT VENTING 

Wine Cellar ONLY.

#1. Vintec “Built in” Wine Cellar are front venting but 

       are not designed to be fully integrated behind a 

       joinery door.

#2. Vintec “Built in” Wine Cellar require 10mm clearance

      on both sides and top, 30mm clearance  at the rear

      (Back spacer is provided), to facilitate  installation, 

      removal, servicing and ventilation.

#3. Vintec “Built in” Wine Cellar draw air from the rear

      and expels it through the metal grid under the door at 

      the front. If a kick board is to be placed in front of the 

      Wine Cellar grid another one must be fitted into the 

      kick board with a minimum air flow allowance of 

      150

cm²

.

#4. Vintec “Built in” Wine Cellar have  a power switch l

      ocated on the control panel so power point location 

      is not critical.

#5. The Wine Cellar requires a standard 240 volt/10 amp 

       power point. (Or according to different countries 

       specifications).

#6. The power cord is 1.9m in length and is fixed on the

       right side at the back when looking from front of 

       cabinet.

#7. As with most appliances of today, the Wine Cellar has 

      sensitive electronic components which are susceptible

      to damage through lightning and electricity supply 

      faults. It is therefore advised to use a power surge

      protector to avoid problems of this nature. 

#8.

 Air vent within the joinery must be provided for 

      Vintec built in Wine Cellar  (front venting)

In Hot climate zone, an air vent or grid, with a minimum 

ventilation size of 200mm x 40mm MUST be cut out at

the rear top of the back partitioning or at the top of 

either side of the partitioning, allowing cool fresh air 

full access to flow into the 30mm gap located at the 

rear of the cabinet. 

This air vent or grid must not be opened on the same 

side as other appliances such as ovens or an area that 

is sealed and without access to fresh cool air.

Cross section  

Dimensional drawings:

VWS048SCA-X

10mm

625mm

5

User Manual