13
Installation
Calibrating a Lens with End Stops
1 .
For a lens that has ends stops; press the button for zoom once,
the drive will automatically calibrate the range from end stop to
end stop.
Manual Calibration for a Lens without End Stops
1 .
For a lens does not have end stops; press and hold the zoom
button for 2 seconds to initiate the learning mode, the zoom LED’s
begin to flash.
2 .
Manually move the lens zoom to the start point for zoom.
Press Once to Calibrate Zoom
Press Once to Calibrate Focus
2 .
The Green and Amber LED’s will flash while the calibration takes
place.
3 .
When calibration has completed the Amber LED will go out and
the Green LED will turn solid.
4 .
Repeat the procedure for focus.
Press & Hold for 2 Seconds to
initiate Calibration of Zoom
Press & Hold for 2 Seconds to
initiate Calibration of Focus
3 .
Press the zoom button again, and then move the zoom position of
the lens to the end point.
4 .
Press the zoom button again. The motor will then move to the
extremes to confirm end points; calibration is complete.
5 .
Repeat the procedure for focus.
