5
OPERATING YOUR WINE CELLAR
The wine cellar should be placed in where the ambient temperature is between 5-35
℃
(40-95 degrees
Fahrenheit). If the ambient temperature is above or below this range, the performance of the unit may be
affected. For example, placing your machine in extreme cold or hot conditions may cause interior
temperatures to fluctuate. The range of 5 -18
℃
(40-65 degrees Fahrenheit) may not be reached.
The controls of your Wine Cellar
•
RUN
Indicator light illuminates to signify the cooling mode is currently in operation.
•
Button
•
To control the inner light turn on/off.
•
Temperature
To shows the temperature of the wine compartment.
•
Button
Used to raise(warm) the temperature in 1
℃
.
•
Button
Used to lower(cool) the temperature in 1
℃
.
Setting The Temperature Controls
•
To set the temperature, connect the power cord to a properly grounded outlet. In the event of
power interruption, the previous temperature setting is automatically erased.
•
Set the desired cooling temperature by pressing the buttons adjacent to the “ / “button.
Each press of the buttons will scroll through the available temperature setting in increments of 1
degree. The temperature selected will flash in the LED display for approximately 5 seconds,
then revert back to display the temperature of the wine compartment.
The temperature setting can be adjusted from 5
℃
to 18
℃
.
•
To view the "set" temperature, (anytime) press and hold the “ / “ button for approximately
5 seconds, the "set" temperature will temporarily "flash" in the LED display for 5 seconds
•
Flashing LED = Set Temperature
Steady LED = Cabinet Temperature
NOTE:
•
If the unit is unplugged, power lost or turned off, you must wait 3 to 5 minutes before restarting
the unit. If you attempt to restart before this time delay, the wine cellar will not start to operate.
•
When you use the wine cellar for the first time or restart the wine cellar after having been shut
off for a long time, there could be a few degrees variance between the temperature you select
and the one indicated on the LED display. This is normal and it is due to the direction of the
activation time. Once the wine cellar is running for a few hours everything will resume to normal.
