NO BOLT
LEAVE
OPEN
9.3
A1-A2
B1-B2
9.2
Secure with bolt
NO BOLT
9.1
9. Similar to step 5 previously; fit two remaining support legs B1 & B2 into the A1 & A2 handrails
respectively (A1+B1 & A2+B2 - see step 5 & 9.2). Secure connecting parts at ONLY
ONLY
ONLY
ONLY one bolt location (see
9.1 & 9.3). The open bolt hole in parts A1-B1 & A2-B2 will be addressed in step 13 to follow. Secure with
single 3/4 carriage bolt with washers & nuts on the inside face of each support leg / handrail set.
NO BOLT
10. NOTE
NOTE
NOTE
NOTE: This side of the ladder will be adjusted
: This side of the ladder will be adjusted
: This side of the ladder will be adjusted
: This side of the ladder will be adjusted
for the
for the
for the
for the INSIDE
INSIDE
INSIDE
INSIDE of the pool
of the pool
of the pool
of the pool. Similar to step 6; fit two
remaining adjustable base supports (C1 & C2) over
support legs (B1 & B2). Adjust the base supports to
the inside
inside
inside
inside measurement using the measurement
guide markings (10.1). Make certain to add the 1
inch for pool clearance. Adjust both inside support
legs the same. Align bolt holes & secure each base
support at ONLY
ONLY
ONLY
ONLY three locations (10.2 & 10.3),
leaving indicated bolt hole open until step 13.
Similar to step 7, fit remaining base tread D (10.4).
10.1
10.2
10.4
11.1
10.3
NO
NO
NO
NO
BOLT
BOLT
BOLT
BOLT
BOLT
BOLTS
LEAVE OPEN
INSIDE TOP
BOLT HOLE
(Both sides)
11. Stand ladder in upright position on a flat
surface. Base treads are pivotal; they can be
adjusted back & forth so ladder in stable. Adjust
both treads appropriately (11.1). Using a 1/8 drill
bit, drill a pilot hole through both ends of base
tread & base support (11.2). Secure using 3/4
screw provided (11.3). Repeat for both base treads
11.2
11.3
12. For both inside (in-pool) & outside (exterior) portions of ladder,
fit ladder sections F into assembled frame. Slide ladder sections
down the channels of the handrails and support legs, left and right,
from top to bottom (12.1 & 12.2). The ladder section will only slide
down as far as the catch of the locking mechanism (12.3). Using
the finger hole on the outside of the locking mechanism (A2 hand-
rail - right side) pull the locking mechanism out allowing the ladder
section to continue to slide down (12.4). Gently fit & slide ladder
sections down to bottom on both sides of the ladder (12.5).
12.2
12.3
12.4
12.5
12.1
