POV.HD User Manual
Using the Recorder
19
•
Select
USB Mode
to connect to the computer via USB. While in USB Mode, the recorder cannot be
used for any other function.
•
On a Mac, the recorder will appear in the Finder as an external drive.
•
On a Windows PC, in Windows Explorer, the POV.HD will appear as a removable disk under My
Computer.
• Up to this point, the procedure is the same as that used to upload clips, but now simply play the
clips that are on the recorder the same way you play clips that are stored on a local drive.
Note
: Always upload clips before using an external video editor on them. Even though it is possible to use
a computer based video editor to edit clips while they are still on the recorder, this is not recommended.
Space on the SDHC card is limited and your editor may not be able to complete it’s operations
successfully. Edited clips may not be recognized and handled correctly by the recorder firmware.
Change the remote ID channel on the remote control
If you are using more than one POV.HD and/or POV.1.5 system in the same area, at the same time you will
need to adjust the Remote ID channel numbers that the wireless remotes are using to communicate with the
POV recorders so that each POV is using a different channel.
The remote control and POV recorder it is associated with must be set to the same channel in order to work
together, but must be different than other POV’s in use in the same area.
The Remote ID channel of the wireless remote is set using a small rotary dial located inside the remote
control.
• To adjust the channel you will need to open the remote control unit by removing the four small
Phillips screws at the four corners of the remote.
•
Use a small flat bladed screwdriver to carefully rotate the pointer to the desired setting. Take care
to protect the inner workings of the remote from dust and moisture while the cover is removed
•
Replace the cover, tightening the four screws uniformly to create even pressure against the seal
Change the remote ID channel on the POV.HD
To change the Remote ID Channel on the POV.HD,
•
Go to
Settings
and locate
Remote ID Channel.
•
Set the
Remote ID Channel
to the same channel number that the wireless remote has been set to.
•
Check the wireless remote to see that it is communicating correctly with the recorder. See
Check
the Wireless Remote
, above.
STOP
REC/TAG
5 6 7
8
9
0 1
2
3
4
5 6 7
8
9
0 1
2
3
4
1. Remove these screws
2. Separate the top and bottom.
3. Turn the arrow to the
desired channel setting
using a small, flat-‐bladed
screwdriver.
