The Remote Control and POV.1 must be set to the same REMOTE I.D. in order to operate. The
POV.1 and remote control are shipped with the REMOTE I.D. set to 0. The 10 available
REMOTE I.D. settings allow multiple POV.1's and their Remote Controls to be used in close
proximity without interference.
Press the Settings button and then PREV or NXT to navigate to REMOTE I.D. Press SELECT,
press PREV, NXT to desired setting, press SELECT. The Remote Control’s I.D. setting adjuster
is a rotary dial inside the remote.
To open the remote and adjust its I.D. setting:
Place the remote on a flat surface with the
buttons up. Unscrew the four small Phillips screws and lift the cover from the remote. Use a
small flat blade screwdriver to carefully rotate the pointer to the desired setting. Take care to
protect the inner workings of the remote from dust and moisture while the cover is removed.
Replace the cover, tightening the four screws uniformly to create even pressure against the seal.
Remote with cover removed. I.D. set to 0.
The Remote control uses an A27 battery, included, and shown in above photo.
FCC Compliance
The V.I.O. POV-1 has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
