User Manual
Arctic 3G Gateway
Firmware Version 2.1.x
11
Document Version 3.1
2.3
LEDs
2.3.1
Status LEDs
Arctic 3G has 11 status LEDs. They are located on the front panel (see
section 2.1).
Table 1: LED Description
LED State
Meaning
On
Unit is restarting. LED should turn off after restart (usually about
30 seconds). If the LED is constantly turned on for a long time you
should contact technical support.
Blinking There is something wrong with the unit or the power supply causes
the unit to restart constantly. You should try with another power
supply and if that does not help, contact technical support.
Error
Off
Unit is operating normally.
Blinking Unit is operating normally
RUN
Off
If the unit is turned on and RUN led is not blinking, the system has
catched an error and is waiting for restart. The unit should restart
soon.
On
VPN connection is up
Blinking VPN connection is starting
VPN
Off
VPN connection is disabled
FW
-
Reserved for future use
On
SIM card has been found and it is ready for use.
Blinking SIM card initialization is in progress.
SIM
Off
SIM card is not in use
On
Signal level is normal or good (better than -95 dBm)
Blinking Signal level is weak (between -110 dBm and -95 dBm)
SIG
Off
There is no signal (below -110 dBm)
On
3G connection is up
Blinking 3G connection is starting. If the connection is not coming up, check
the SIM and SIG LEDs
COM
Off
3G connection is stopped
APP -
Reserved for future use
USR -
Reserved for future use
RS1 -
Reserved for future use
RS2 -
Reserved for future use