7
Section 5: Mount Installation
This monitor ONLY includes screws which may be used when attaching the monitor to a
VESA 100x100mm mount. No mount or mounting accessory is included.
Keep the foam underneath the monitor before attaching it to a mount or accessory. No
mount or mounting accessory is included.
1. Open the package, take out the product with foam still attached, and gently place it on a
desktop or table. Remove the extra parts and the foam covering the back of the monitor.
If the monitor is already attached to the stand, remove the stand. If the stand was not
installed, press the button to remove the stand plate.
Button
Stand Plate
2. Remove the original screws x 4 (
1
) from the opening in the back of the monitor. Follow
the directions received with your mount, stand, or accessory and install the monitor on the
wall or fixture as desired. Remember to use the included NO. 2 screws when attaching
anything to the back of the monitor (
2
).
1
Original Screws x 4
NO. 2 Screws x 4
2
- Do not discard the original screws or the stand plate.
- Use only the NO. 2 Screws (
2
) provided when attaching the monitor to a VESA
100x100mm mount.
3. Follow the directions received with your mount, stand, or accessory and install the monitor
on the wall or fixture as desired.
Mount
(Not included)
Summary of Contents for GN34CB
Page 19: ...19...