Manual VIPA HMI
Chapter 2
Deployment Touch Panel
HB160E - TP - RE_610-1BC00 - Rev. 08/13
2-25
Integration to WLAN network
By plugging a WLAN card there is the possibility to integrate your Touch
Panel to a WLAN network. For this driver for the corresponding WLAN
hardware are pre-installed.
Please regard only SDIO WLAN cards are supported which drivers are pre-
installed in the Touch Panel. In the Touch Panel driver exist for the
following SDIO cards:
•
Socketcom P300
•
Spectec SDW821
•
JustMobile Wireless LAN Card.
•
PowerON the Touch Panel.
•
Plug the SDIO card
→
the SDIO card is identified and a dialog window,
which shows the available WLAN networks, is opened.
•
Continue with "WLAN integration".
Please regard only WLAN-USB sticks are supported with the chip of the
company
Funkwerk
inside!
•
PowerOFF the Touch Panel.
•
Plug the WLAN USB stick to the USB-A interface.
•
PowerON the Touch Panel
→
the driver name is requested.
•
Enter "prisma02"
→
now your card is installed and activated.
Note!
To keep the settings also after PowerON, you have to store them to the
registry with
START
>
Programs
>
KuK Tools
>
Save Registry
.
Directly after installation a dialog window is shown. Here the available
WLAN networks are displayed.
Chose the corresponding network and click to [Connect].
At a safety-relevant network set the network parameters and enter the
network key. If the parameters are correct the connection is established.
Overview
WLAN via
SDIO card
Installation
WLAN via
USB stick
Installation
WLAN integration
Summary of Contents for 610-1BC00
