Manual VIPA HMI
Chapter 2
Deployment Touch Panel
HB160E - TP - RE_62F-DCB0 - Rev. 11/14
2-3
For the cabling of the DC 24V power supply green plugs with CageClamp
technology are deployed. The spring-clip connector technology simplifies
the wiring requirements for signaling and power cables. In contrast to
screw terminal connections, spring-clip wiring is vibration proof.
Here also you may connect wires with a cross-section of 0.08mm
2
to
2.5mm
2
. You can use flexible wires without end case as well as stiff wires.
Fix the conductors to the CageClamps like this:
DC 24V
1
2
3
[1] Round opening for wires
[2] Locking (orange) for screwdriver
[3] Test point for 2mm test tip
1
2
3
The picture on the left side shows the cabling step by step from top view.
•
For cabling you push the locking vertical to the inside with a suiting
screwdriver and hold the screwdriver in this position.
•
Insert the insulation-stripped wire into the round opening. You may use
wires with a cross-section from 0.08mm
2
to 2.5mm
2
.
•
By removing the screwdriver the wire is connected safely with the plug
connector via a spring.
Connect
power supply
