33
© 2016 Directed. All rights reserved.
Feature Details
33
Trigger Zone Fault Report
When armed by remote command the system runs a status check
of the alarm trigger zones. Faulty zones (usually caused by dome
light delay or open trunk) are bypassed and reported via the control
center LED and remote, while all other trigger zones remain active
and are monitored to protect the vehicle. Should a faulty zone self
correct (dome light turns off) it becomes active and is then monitored
normally.
The siren chirps once again a few seconds following the arming
chirps as an audible alert, the Control Center LED flashes in groups to
indicate the zone number. The remote will emit a single fault tone and
play zone specific text that identifies the faulty zones.
Alarm Report when disarming
The most recent alarm triggers (if any) are reported when the alarm
is disarmed via the remote control, siren chirps, parking light and
Control Center LED flashes. The siren chirps four times (or five times
if NPC ON*), the parking lights flash three times, and the control
center LED flashes in groups to indicate the last two zones that were
triggered (see
Table of Zones
). The
DISARM
text is replaced by
ALARM REPORT
and text identifying the triggers.
* See
“NPC (Nuisance Prevention Circuitry)” on page 34
for
more details.
Summary of Contents for 5706V
Page 1: ...M O D E L 5706V O W N E R S G U I D E NO ONE DARES COME CLOSE...
Page 2: ......
Page 68: ......
