42
© 2016 Directed. All rights reserved.
42
Valet Mode
Valet mode can be entered and exited by performing the Remote Valet
command or manually using the vehicle key and the control button.
When entered, the alarm functions are defeated while the conve-
nience features still operate normally.
Arm and Disarm commands lock and unlock the doors while the
VALET
text and beeps play to confirm.
Use the following steps to manually enter and exit Valet Mode:
1.
Turn
the ignition switch ON and then OFF.
2. Immediately
press
and
release
the Control Center button once.
3. The Control Center LED turns on when entering, and off when
exiting.
Power Save
To reduce power consumption the control center status LED modifies
its output if the vehicle is parked for an extended period. If Armed the
flashing is reduced after 24 hours. When Valet mode is ON, the LED
will turn off one hour and will reset each time the ignition is turned off.
Rapid Resume
If power is disconnected by a mechanic or thief, the system will retain
the last state that it was in when power is restored.
Automatic Remote Updates
The system sends a silent message to all remote controls after any
major action has occurred. When the remote receives this message it
updates the status screen icons. This way all users are able to quickly
review the system status just by accessing the status screen.
Summary of Contents for 5706V
Page 1: ...M O D E L 5706V O W N E R S G U I D E NO ONE DARES COME CLOSE...
Page 2: ......
Page 68: ......
