36
© 2006 Directed Electronics—all rights reserved
feature descriptions
The features of the system are described below. Features that have additional settings that can be selected only
when programming with the Bitwriter are indicated by the following icon:
1-1 ACTIVE/PASSIVE ARMING:
When active arming is selected, the system will only arm when the transmitter
is used. When set to passive, the system will arm automatically 30 seconds after the last door is closed. To alert
the consumer of passive arming, the siren will chirp 20 seconds after the door is closed. This provides the con-
sumer with an audible warning prior to the system actually arming. At the 30 second mark, the system will arm,
but the siren will not chirp.
menu #1
FEATURE
DEFAULT - LED ON SETTING
LED OFF SETTING
NUMBER
(PRESS CHANNEL 1)
(PRESS CHANNEL 2)
2-1
Engine check ON
Engine check OFF
2-2
Tachometer engine check
Voltage engine check
2-3
12 minutes run time
(1)
24 minutes (2), 60 minutes (3) run time
2-4
Flashing parking light output
Constant parking light output
2-5
Cranking time 0.6 sec.
(1)*
Cranking time 0.8 (2), 1.0 (3), 1.2 (4), 1.4 (5),
1.6 (6), 1.8 (7), 2.0 (8), 4.0 (9) sec.*
2-6
Voltage check high level
Voltage check low level
2-7
Short run (turbo) 1 minute
(1)
3 (2), 5(3), 10 (4) minutes
2-8
Activation pulse: 1 (1)
Activation pulses: 2
(2), 3 (3)
2-9
2nd Ignition output
2nd Accessory output
2-10
Accessory state during wait to start OFF
Accessory state during wait to start ON
2-11
2nd status output NORMAL
(1)
Rear defogger latch (2), rear defogger pulse (3)
2-12
Anti-Grind ON
Anti-Grind OFF
2-13
Diesel timer Wait-to-Start input
(1)
Timed 15 (2), 30 (3), 45 (4) seconds
2-14
Run Time (Timer Mode) 12 minutes
(1) 3 (2), 6 (3), 9 (4) minutes
*
NOTE:
The numbers in parentheses indicate the number of times the LED will flash.
menu #2
