© 2008 Directed Electronics- All rights reserved.
15
Important!
To achieve the best possible range, DO NOT leave the
antenna receiver cable bundled under the dash. Always extend the
cable full length during installation, regardless of the antenna mounting
location
.
Antenna receiver cable
ANTENNA RECEIVER
On-Board Dual-Stage Shock Sensor
There is a dual-stage shock sensor inside the control unit. Adjustments are
made via the rotary control as indicated in the diagram. Since the shock sensor
does not work well when mounted firmly to metal, we do not recommend
screwing down the control module. The full trigger of the on-board shock
sensor reports Zone 2. (See Table of Zones section of this guide.)
Note: When adjusting the sensor, it must be in the same mounting location
that it will be after the installation is completed. Adjusting the sensor and then
relocating the module requires readjustment.