© 2008 Directed Electronics- All rights reserved.
18
System Features Learn Routine
The System Features Learn Routine dictates how the unit operates. Due to
the number of steps, they have been broken up into two menus. It is possible
to access and change any of the feature settings using the Valet/Program
switch. However, this process can be greatly simplified by using the 998T
Bitwriter. Any of the settings can be changed and then assigned to a particular
transmitter, up to four, a feature called Owner Recognition. Each time that
particular transmitter is used to disarm the system, the assigned feature settings
will be recalled. Owner Recognition is only possible when programming the
unit via the 998T Bitwriter.
If the system was previously programmed using the 998T Bitwriter, the learn
routine may be locked. If the siren generates one long chirp when attempting
to program the unit, the learn routine is locked and must be unlocked using
the 998T Bitwriter.
1.
Open a door.
(The H1/5 GREEN wire or the H1/7
VIOLET wire must be
connected.)
2.
Ignition.
Turn the ignition on, then back off: (The
H1/9 YELLOW wire must be connected.)
3.
Select a Menu.
Press and HOLD the Valet/Program
switch: (The Valet/Program switch must be plugged
into the blue port.) After three seconds the siren will
chirp once indicating entry to the Basic Features Menu
#1. If this is the menu you wish to access, release the
button and go on to Step 4. If the button is not
released, you will jump to the Advanced Features Menu
#2 and the siren will chirp twice. Once you have
selected the desired menu, release the Valet/Program
button and then proceed to Step 4.
