Step3
After restart the system, a removable HDD is added to
[My Computer]
.
Choice the removable HDD and click right bottom of mouse. Select the
[format]
to format your USB 2.0 Hard Disk Drive.
You only can set the USB 2.0 Hard Disk Drive to one partition in this method.
Method 2
Step1
Go into the MS-DOS mode by click on
[Start]
, choice the
[MS-DOS
Prompt]
in
[Programs]
Step2
At the DOS prompt, type
[FDISK]
and press Enter.
Step3
If FDISK quit without any message, back to the Windows 98 screen, plug
out the USB 2.0 Hard Disk, re-boot computer, plug in USB 2.0 HDD again
and go back to step 1 to proceed.
Step4
In the first screen of FDISK, answer the question:
Do you want to enable large disk support?
[Y]
if you want to build a partition larger than 2GB.
[N]
if you want to build a partition small than 2GB.
22 USB 2.0 External Drive
