Before Use
13
EN
Remove the batteries if the inspection camera will not be used for a
long time.
Inserting / replacing the batteries
• Press the locking tab
A
and lift the
battery cover
17
.
• If necessary, remove the used
batteries and dispose of them
properly.
• Insert four new batteries of the type
LR6 / AA according to the polarity
markings (
+
/
–
) inside the
battery compartment.
• Replace the battery compartment
cover and press it down until the
locking tab clicks into place.
• Press the flap of battery
compartment cover conciously back
so that it snaps into place.
You need four LR6 / AA 1.5 V batteries to operate the inspection camera
10
(included in the supply).
You need to insert or replace the batteries in the following situations:
- when using it for the first time;
- if the status line of the display
29
shows the battery symbol ;
- when the inspection camera cannot be switched on.
The battery compartment
19
is at the back of the inspection camera.
Proceed as follows to insert or replace the batteries:
17
A