-EN-
When the camera is running and the batteries are completely charged the start-up
button is
green
.
While the batteries are loading (3h max), the button
flashes red
.
After the batteries are charged the button
glows
steady red.
The battery charge indicator is in the top right of the screen.
The batteries must be recharged when the indicator shows a low charge level:
1 -
Connect the system‟s power supply unit to the slot provided on the
2 - Connect the power unit to the mains.
When placed to charge, only the battery in the top corner will be charged. You must
swap the batteries round to charge the 2
nd
one.
An external quick charger is available as an accessory (ref. 294032) to charge each
battery separately (charge time: +/- 1h30)
b) Setting the date and time (294030/294040)
1
–
With the camera off, pre
ss the ▲ key and hold it
down while switching the camera on.
2
– A menu appears on the screen: Date / time /
measurement unit (metres or feet) / date indication
format
DD.MM.YY or DD/MM/YY) / 12 or 24-hour clock.
3
– The arrow keys are used to browse the menus
and the values can be modified using the up and
down keys.
4
– Press the ON / OFF button to exit the menu
c) Use
Once the Visioval has been switched on, simply pull the cable and push it into the
pipe or place to be inspected.
-
Pull and push the cable in a regular and even manner; do not force the
cable if it becomes jammed. Do not rub the cable on sharp edges. Do not
fold or twist the cable.
-
Always remember to protect the content of the case from water.
Before you roll the cable up inside the case, ALWAYS wipe the flexible cable with a
soft, damp cloth (no solvents). If the lens is dirty, wipe it with a soft, damp cloth (no
solvents).
Summary of Contents for VISIOVAL 294020
Page 75: ......
Page 76: ...Juin 2011 ...
