EN
VirtuFit CTR 3.0i Elliptical Trainer
19
• This unit requires a 9V, 500mA adapter. If the meter does not display properly, pull the Unplug the
power cord and plug it in again.
• When the user stops pedaling for 4 minutes, the computer enters power saving mode, all settings
and training data are saved until the user starts again with train.
• If the computer shows abnormal values, unplug the power cord from the power outlet, so that the
power is off and reconnect it.
E1
De console ontvangt geen FAT testsignaal, pak de sensoren beide goed vast.
E1
Console is not receiving a FAT test signal, grasp both sensors securely.
E2
Check if the motor exceeds the range of the console.
E4
The set age, height and weight exceed the set range of the console, please set it based on the actual values
of the user.
E5
Check that the 12-pin (9-pin) wire between the console and the machine is properly connected without
breaking contact.
E7
Check that the 12-pin (9-pin) wire between the console and the machine is properly connected, without
breaking the contact (with CD motor).
ERROR CODES
TROUBLE SHOOTING
