EN
VirtuFit Indoor Cycle S2i Spinbike
8
STEP 3
ASSEMBLY INSTRUCTIONS
6 VSLQ ELNH
67(3
&RQQHFW H[SRVHG HQG RI ZLUH LQ 67(3 ZLWK FRQVROH WKHQ XVH VHPLFLUFXODU KHDG FURVV IORZHU
VFUHZ0& DQG SDG ĭ& WR IL[ FRQVROH RQ WKH KDQGOH DGMXVWPHQWDQG XVH VHPLFLUFXODU
KHDG FURVV IORZHU VFUHZ 0& SDG ĭ& WR IL[ FRQVROH UHDU FRYHU RQ WKH FRQVROH WKHQ
XVH 1\ORQ PDW 6& SDG ĭ&VSULQJ SDG ĭ& DQG VHPLFLUFXODU KHDG FURVV IORZHU
VFUHZ0& WR IL[ ERWWOH FDJH RQ WKH KDQGOH DGMXVWPHQW DQG WKHQ DGMXVW KDQGOH
DGMXVWPHQW WR WKH IROORZLQJ SRVLWLRQ WKHQ XVH IODW FRXQWHUVXQN KHDG LQQHU KH[DJRQ VFUHZ 0
QRW LQ WKH SODVWLFDEVRUELQJ WRRO SODWH DOUHDG\ DVVHPEOHG ZLWK KDQGOH DGMXVWPHQW WR IL[ KDQGOH
喈
喉
RQ WKH KDQGOH DGMXVWPHQW DW ODVW VFUHZ WLJKWO\ SHGDO RQ WKH FUDQN
喈
SOHDVH DWWHQWLRQ RQ OHIW/
SHGDO DQG ULJKW5 SHGDO DQG VFUHZ WLJKWO\ LQ WKH GLUHFWLRQ RI WKH IURQW RI ELNH
• Use the M5 * 12 (C1) Phillips screw and the ø5 (C2) ring to attach the console (2) to the handlebar (8)
confirm. Then connect the sensor cables.
• Attach the aluminum protection cap (11) with the Phillips screw M5 * 20 (C6) and ring ø5 (C2).
• Use nylon washer S1151 (C3), washer ø5 (C2), spring washer ø5 (C4) and Phillips screw M5 * 16 (C5) to
mount the bottle cage (3) on the handlebar (8).
• Place the steering rod (8) in the position as shown in the figure. Use the countersunk head screw
M8*16 to attach the handlebar (7) to the handlebar (8). Pay attention! This hex screw is already
attached to the steering rod (8).
