1717 W Civic Drive, Milwaukee, WI 53209
414-354-6600
Design Modification Rights Reserved
© 2018 Visa Lighting
When using electrical equipment, basic safety precautions should always be followed, including the following:
•Read all instructions carefully before installing and save for future use.
•Make sure all connections are in accordance with the National Electrical Code and local regulations.
•To avoid possible electric shock, be sure the power supply is turned off before servicing or installing the fixture
•Service should be performed by qualified personnel.
•These instructions may not cover all details or variations. If additional information is needed, please contact Visa Lighting.
!
Model: CV2424
Linesse Linear Slot
Publication: 762302XX
Document Description: Installation Instructions
for 3” Linesse Linear Recessed
Series Luminaires
6
INSTALLATION INSTRUCTIONS FOR MOUNTING
IN HARD CEILING AND JOINING FIXTURES (cont.)
1. For row mounting fixtures attach
male end of harness to female end
of harness. Small lens sections are
centered between fixtures to avoid
light leak at lens ends.
2. Slide fixture together using sliders
that extend from fixtures to insure
proper alignment.
3. Screw internal reflectors down
to joining fixture.
4. Tuck harness at end of rows and
attach end caps using supplied screws.
5. Replace Lens.
6. Finish mud over flangeless trim
making sure no screw heads
are exposed.
7. Clean around exposed area.
Starter Harness
(1st Fixture)
Through Harness
Sliders
Lens
Through Harness
Inside View
Fasten extended reflector tabs
to joining fixture.
Carefully break tab at end of run
Fasten end cap to end of run
Mud and sand over “Trimless”
trim before painting
