Operation
14
Selecting the brush adapter
Adjust the size of the brush adapter used to the length of your hair. Use
the volume brush for long hair and the round brush for shorter hair.
This product comes with two different brush adapters which you can change: The
round brush adapter
7
and the volume brush adapter
2
. Proceed as follows to
change the brush adapter:
1. Make sure that the mains plug has been pulled from the socket.
2. Make sure that the function switch
4
is set to the
0
position (see
Fig. B
).
3. Press the lock button
1
(see
Fig. C
) and remove the brush adapter.
4. Attach the desired brush adapter to the handheld section
6
(see
Fig. D
) until
you hear it click into place.
You can now use the product.
Selecting a function level
The following table provides an overview of the function levels available.
Function level
Property
0
Off
C
cold high airflow
1
hot low airflow
2
hot high airflow
Styling your hair
1. Make sure that the function switch
4
is set to the
0
position (see
Fig. B
).
2. Connect the product to a properly installed socket only.
3. Slide the function switch to the desired function level (see table in chapter
‘Selecting a function level’).
4. Separate a strand of hair from the rest of your hair.
5. Place the hair tips on the brush adapter
2
or
7
.
6. Push the direction of the rotation switch
3
in the desired direction to wind your
strand of hair onto the brush adapter (see
Fig. E
).
7. Depending on the desired intensity, hold the wound up strand of hair on the
brush adapter for a brief moment.
8. If necessary, use the cold air function to fix your hair. To do so, switch the function
switch to position
C
.
