Programming
1.
Enable program mode.
2.
Tap the “Bank” Up/Down buttons to select the bank containing the scene you
wish to copy.
3.
Select the scene you wish to copy by pressing its scene button.
4.
Using the “Bank” up/down button select the bank you wish to copy the scene
to.
5.
Tap the Midi/Add button.
6.
Tap the scene button you wish to copy the scene to.
Deleting a Scene
1.
Enable the program mode.
2.
Press the desired “Scene” button to select the scene you wish to delete.
3.
3. Press and hold down the “Auto/Del” button. While holding the button, tap
the scene button that corresponds with the scene you wish to delete.
4.
When the programmed scene is deleted, all DMX channels values will be set
to “0”.
Deleting All Scenes
1.
With the power “Off” press and hold down the “Program” and “Bank Down”
buttons at the same time.
2.
Turn the unit back on, all scenes should be cleared.
Copy A Bank Of Scenes
1.
Enable the program mode.
2.
Tap the “Bank Up/Down” button to select the bank you wish to copy.
3.
Tap the “Midi/Add” button
4.
Tap the “Bank Up/Down” button to select the bank you wish to copy to
5.
Tap the “Music/Bank copy” button, all LED’s will briefly flash three times
Power Switch
This switch turns the power On/Off to the DMX 192J.
Operation
The Visage Club allows you to program 12 scanners with up to 16 channels
each, 30 banks of 8 programmable scenes, 6 chases of 240 scenes using 8
channels sliders, and other buttons.
Unit Setup
The unit is preset to allocate 16 channels per fixture. In order to assign your
fixture to the scanner buttons located on the left side of your controller you
will need to “Space” your fixtures 16 DMX channels apart.
The following is only an example of DMX address settings requiring 16
channels each to program:
Fixture # Digital # Dip Switch Setting
1 1 1 “On”
2 17 1 & 5 “On”
3 33 1 &6 “On”
4 49 1,5, & 6 “On”
5 65 1 & 7 “On”
6 81 1.5 & 7 “On”
7 97 1, 6 & 7 “On”
8 113 1,5, 6 & 7 “On”
9 129 1 & 8”On”
10 145 1,5 & 8 “On”
11 161 1,6 & 8 “On”
12 177 1,5,6 & 8 “On”
