Enabling The Program Mode
To enable program mode, hold the “Program” button for 3 seconds until the
LED is lit.
Programming Scene
1. Enter program mode (See Enable Program Mode).
2. Check the blackout key and verify that the LED is not lit. If it is, press it once
to exit blackout mode.
3. Verity that the “Speed” and “Fade” time sliders are positioned at zero.
4. Press the scanner button corresponding to the unit you wish to control. You
may control more than one scanner at a time at pressing the button
corresponding to the scanner(s) you wish to program.
5. Move the faders and joystick to the desire position. If necessary, you may
select page “B” to control channels 9-16.
6. Tap the “Bank” UP &Down buttons to choose the bank onto which you want
to store this scene.
There are a total of 30 banks you can select. You may store up to 8 scenes in
each bank.
7. Once all the scanners are programmed into the desired positions for the
scene, tap the “Midi/Add” button to program this scene into memory.
8, Tap the scene button you wish to store your scene into. All LED’s will flash
three times signifying this operation.
9. Tap unselect the scanner(s) you have been programming again.
10. Repeat steps 2-7 until all scenes have been programmed.
11. If you do not intend to continue programming at this time, press and hold
the program button for 3 seconds to exit program mode.
The LED will go to out indicating this selection. Example: scene program
1. Enable “Program” mode
2. Tap the scanner 1 button to turn to its fader control.
3. Verify that the page is sent on ‘Page A”, if not, press the page select button to
select “Page A”.
4. Move the first and second faders all the way up to maximum value position.
5, Select ‘Bank 1”using the “Bank Up/Down” buttons.
6. Press the “Midi/Add” button.
7. Tap scene 1 to store the first scene.
8. Repeat steps 4-7 until all scenes have been programmed into “Bank 1”.
9. Tap the scanner 1 button to turn off the fader control.
10. When finished, disable program mode. You can now manually tap through
what you have just programmed.
Editing A Scene
1. Enable “program” mode.
2. Press the “Bank” Up/Down button to select the bank containing the scene you
wish you edit.
3. Select the scene you wish to edit by tapping its scene button.
4. Use the faders and joystick to make the desired adjustments to the scene.
5. Once you have completed the changes, tap the “Midi/Add” button.
6. Tap the scene button that corresponds to the scene you are editing, this will
override the exciting scene.
Be sure select the same scene in steps 3 and 6, otherwise you may accidentally
record over an exciting scene.
