8 / 16
Spraying System eco-CONTROL SC1200
Commissioning and maintenance manual
Copyright
©
8. PARAMETER:
• Select mode
Pressing the PROG key switches to the next program and to manual mode
Manual:
In this mode, the dispense time get not saved and the spray valve
dispenses as long as the dispense signal is activated on one of the fol-
lowing possibilities: foot switch / purge key / I/O-start. After dispens-
ing, the dispense time starts again at 0.00 sec.
PROG 1-7: If one of the programs 1 – 7 is selected, the SC1200 dispenses as long
as the value of the dispense time is saved. It is independent how long
the dispense signal is activated on one of the following possibilities:
foot switch / purge key / I/O-start.
This mode should be selected, if the dispensing valve should always
dispense for the same time.
• Set the spray time:
The spray time can be selected with the UP / DOWN keys. The spray time can
be set from 0,01 ... 999.99 sec
• Set the pre spray time:
The press pray time can be selected with the UP / DOWN keys. The pre spray
time can be set from 0,01 ... 5.00 sec. The pre spray time is the time how long
the nozzle sprays air, before the control air opens the material path of the
spray valve. This is necessary for cleaning the nozzle before spraying.
• Set the postspray time:
The post spray time can be selected with the UP / DOWN keys. The post spray
time can be set from 0,01 ... 5.00 sec. The post spray time is the time how long
the nozzle sprays air, after the control air closes the material path of the spray
valve. This is necessary for cleaning the nozzle after spraying.