Owner's Manual – Viscount Cantorum V
TRANSMISSION OF PROGRAM CHANGE
For each of the 12 memories you can associate a Program Change number to be transmitted when
the memory is recalled. The Program Change can be sent to any of the section (and their related
MIDI channels).
To transmit and enable the transmission of Program Changes first enter the Program Change MIDI
Set mode by pressing for approx. 2 seconds the
[TRANSPOSER]
button. The green
[TRANSPOSER]
LED will start flashing. To enable the transmission of a Program Change related
to a memory, first press the button related to that memory (if necessary press the
[USER]
button to
switch from factory and user memories). A Program Change number must be set. The stops of
manual I and manual II will blink in sequence to show the actual Program Change number
(numbers 0 to 9 are written under the stops of manual I and manual II; for example: if pressing the
memory button
[
pp
/1]
, the stop labelled “0” blinks twice and then the stop with label “1” once,
indicating that the Program Change number associated to the memory button
[
pp
/1]
is “001”).
Meanwhile the Program Change number will be sent via MIDI.
Now you can enter a new Program Change number for the selected memory: press the stops
corresponding to the number you want to enter.
Every number is made of 3 digits (e.g. to input the Program Change number
nine
you have to press,
in the order: “0”, “0”, “9”). After the third digit has been pressed the
[SPLIT]
LED flashes five
times to signal the success of the operation. If a value outside the 001-128 range is inputed the
procedure aborts and the previous Program Change is retained.
Finally, use the Bass section registers to enable/disable sending of the Program Change to the
related section.
To exit from the Program Change mode press
[TRANSPOSER]
.
Note: If the transmission of MIDI messages has been disabled in every section, Program Changes (as other
messages) won't be sent.
4.6 DEMO SONGS
There are six Demo songs to evaluate and appreciate at best the sound of the instrument. To play
Demo songs press for about two seconds the
[USER]
button, then choose one of the songs by
pressing one of the memory buttons (buttons
[
pp
/1]
to
[TUTTI/6]
).
Press again
[USER]
to exit from Demo mode.
EN - 15
