Viscount Prestige 50, Quick Manual

11

Quick Guide - Viscount

Prestige 50

2.6 CONNECTIONS ON THE REAR PANEL

-

+

EXT.

+12V DC

300 mA

1

2

3

4

L (+R)

R

MIC

GAIN

OUTPUT

INPUT

1

2

3

1. [EXT. +12V DC] connectors:

 these sockets can be used to obtain the +12V DC voltage needed

to supply the VISCOUNT speakers connected to the [OUTPUT].

The external boxes can be switched on and off by using the [EXT. SPK.] switch located on the

left side panel.

2. [OUTPUT] Section: 

this section contains four line outputs for the external organ amplification.

By means of the internal set up functions, which can be called up using the central control unit,

it will also be possible to edit various parameters for these audio outputs (individual volumes,

delays and equalisations) and to set these outputs in such a way as to simulate the wind chests

of the original church organs.

These functions called EXTERNAL OUTPUTS CONTROL and EXTERNAL VOICES

ROUTER are described in the “Advanced Manual”.

WARNING!

-

In order to reach a proper pipes simulation, you have to locate the speakers boxes according

to the output numbers. The speaker box connected to output [1] has to be located on the
extreme left followed by all other speakers connected to outputs [2], [3] and [4] will be
located to the extreme right.

-

The volume controls for the manuals, the pedal board and the Orchestra voices are in the

drawer under the keyshelf (see also par. 3), as well as the expression pedals also affect the
levels of the audio output signals [OUTPUT] found on the back panel and in the drawer
under the manuals. The only control that does not affect these outputs is the [GENERAL]
trimmer.

3. [INPUT] section: 

this section contains the inputs through which the output signal of external

equipment is amplified with the organ’s internal amplification system.

The connections are as follows:

o

[L(+R)], [R]:

 stereo line inputs for connecting instruments with line outputs. For mono

sources use only the socket [L(+R)].

Internal connections by qualified service person only.