26
Changing a Parameter Value
Where an on-screen parameter has to be changed then a
standard method can be used to make the required change.
This method applies across all setup screens in the meter.
A typical example is shown below.
Power Up the Meter for the
First Time
Power the meter on. If the meter asks “New JBox/Trailer swap
detected please confirm” press “No”.
Entering the Setup Menu
Enter the setup menu by pressing the “up” button until you see
“Menu” on the top left of the screen. Press the “Menu” key,
then scroll the cursor down to “Setup” and select it.
You will most likely be asked to enter a PIN number. The
default PIN is 7711, enter this number as explained on the
previous page. Do not give the PIN to truck drivers. You can
change the PIN if needed. This will be explained later.
1.
To change this press button
(edit). This will clear the
long bar and highlight the first changeable value, as shown
in figure. 2.03.
2.
Use buttons
&
to alter the original value to the
required value.
3.
To move to the next value in line press
and repeat as
for line 2.
4.
Once the required value is fully changed press button
,
this will show the new value.
5.
Press button
again to leave the screen.
Note:
After editing any parameter it is essential to exit back to
the user screen as it saves the settings during exiting
the menus.
How to change a
parameter value
The selected parameter is shown by the long grey bar on the
parameter and value.
The value shown in Fig.2.02 is 5500lb.
Fig 2.02
Fig 2.03
SI Onboard TruckWeigh™ Manual
Setup
Summary of Contents for VPG On-Board Weighing SI Onboard TruckWeigh
