14
Positioning of Transducers
on Rear Single Axle Leaf
Springs
The transducers can be mounted on either side of the leaf
spring as shown in the diagrams below. Care should be
taken to ensure the transducer cannot come into contact
with any part of the vehicle during the full range of movement
of the spring.
Fig 1.26
Fig 1.27
Note:
Position of groove
• When the transducers are installed on the rear of
single axle leaf springs, as shown above (see figure
1.26), they are referred to as “leading”.
• Record the transducer orientation into the
Installation
& Calibration Record
for entry into the meter during
its setup.
The TruckWeigh™ axle transducer may also be mounted at the
front of the leaf spring as shown above.
• When the transducers are installed on the front of single
axle leaf springs, as shown above (see figure 1.27
)
, they
are referred to as “trailing”.
• Record the transducer orientation into the
Installation &
Calibration Record
for entry into the meter during its setup.
Front of Truck
Front of Truck
Fig 1.28
Transducer on a single axle spring (rear)
SI Onboard TruckWeigh™ Manual
Installation
Summary of Contents for VPG On-Board Weighing SI Onboard TruckWeigh
