49
In the example above, the front junction box can be left with its default factory
setting as the TruckWeigh™ axle transducers will be numbered 1 – 6 using all
the available sockets on the front junction box.
The rear air transducer interface box will be acting as transducers 7 and 8 (even
if there is only 1 air transducer). It will need to be re-configured to mode 4.
Axles 2 and 3 are likely to be a tandem configuration. If this is the case the
Bogie Mode setting should be configured accordingly – 1,2,[3,4,5,6],7,8
6x4 Tractor/Trailer
Leaf
Spring
Air
Spring
Air
Spring
Air
Spring
Leaf
Spring
Leaf
Spring
TruckWeigh
Indicator
CAN Air Pressure
Junction Box
and
Transducers
Suspension
Air Bags
CAN Junction Box
and
Axle Transducers
TruckWeigh
Truck Air
System
Truck Air
System
Appendix A
SI Onboard TruckWeigh™ Manual
Summary of Contents for VPG On-Board Weighing SI Onboard TruckWeigh
