Visio-tek Wi-
Fi Microscope User’s Manual
page 5
IP Adress
Resolution setting. (When changing the resolution, please wait until the
illumination LED is off and lights up again
–
it takes about 5 seconds).
Resolution setting and Default:
: Enable the button snapshot.
3.2
Calibration on iPhone / iPad
To obtain accurate measurement data for each magnification, please calibrate before performing measurements.
Use the enclosed calibration ruler as to-be-observed
object. Bring the image
into focus by turning the “Focus
& Magnification Adjustment W
heel”;
Click
to pop-up the screen on the left.
Click “Calibration”
, click two dots (move the dot
by clicking
)
in order to draw your desired line, then click on the live
video to show the following screen:
1.
Click to select a point and refine the selection by
clicking the arrows
2.
Select in the same way a second point at a known
distance; in this way a line of known length will be
shown.
3.
Press any point on the screen.
4.
Enter the value of the length and press "Ok".
