BewellConnect - BW-BT1 - User Manual - 2018-03_V1
BewellConnect - BW-BT1 - User Manual - 2018-03_V1
30
31
- Close the Velcro (not too tight).
- Press START/STOP to turn the blood pressure monitor on.
- Put your arm on the table.
- Remain seated and calm for 5 minutes before taking measurement.
- Do not move during measurement.
- To determine which arm you will continue to take readings on, take a measurement on both
arms during your first reading.
In the event of asymmetrical blood pressure (right systolic blood pressure-left systolic blood
press >20 mmHg), take readings from the arm with the highest value except in the event of
contraindications in this arm.
- The measurement will be too low if the armband is higher than the heart or too high if it is
lower than the heart.
Note:
For more reliable results, take measurements on the arm. The measurement results are given for
information. If in doubt about your results, please contact your doctor.
Note : For more reliable results, take measurements on the same arm. The measurement results are
given for information. If in doubt about your results, please contact your doctor.
4.8. USER GUIDE
Note: For an initial use, please insert the batteries into the device (see chapter 5)
Setting the time
- The time is set automatically during the synchronisation of your tensiometer with your
smartphone/tablet.
There are 2 measurement modes: MAM mode and Single mode
MAM mode :
- Three arterial pressure measurements are repeated automatically with 15-second intervals
between each measurement. The armband inflates and deflates 3 consecutive times. Do not
remove the armband before all 3 pressure readings are finished.
Single mode :
- A single measurement is taken.
Recording measurements with the BewellConnect® application
- Launch the BewellConnect® application and click on MyTensio. Activate Bluetooth on your
smartphone or tablet.
- Press the ON/OFF button to switch on the device.
- The default measurement mode is MAM mode (3 measures).
- Press the “START MEASURING” button in the application to launch the measurement. The
armband will inflate automatically.
- At the end of measuring, the results are automatically transferred via Bluetooth 4.0 and
displayed on the application screen.
- Press the ON/OFF button again to switch the device off. If you forget to switch it off, the device
switches itself off after 2 minutes.
Recording measurements without the BewellConnect® application
You can also use your tensiometer without the MyTensio application, the measurements taken
will not be saved in the tensiometer or in the phone.
- Press the ON/OFF button to switch the device on
- Select the measuring mode by pressing the START/STOP button for 5 seconds:
MAM Mode (3 measurements)
Single Mode (1 measurement)
- Press START/STOP to begin measuring. The armband will inflate automatically.
-
At the end of measuring, the results are displayed on the screen of the device.
The colour code on the screen (green, orange, red) indicates your arterial pressure level based
on the classification defined by ESH
- Press the ON/OFF button again to switch the device off. If you forget to switch it off, the device
switches itself off after 2 minutes.
