37
CHAPTER 5: PART REPLACEMENT GUIDE
5.17 Pulley Axle (Secondary) Set Replacement
1) Remove the shrouds as outlined in Section 5.11.
2) Remove the drive belt and generator belt from the pulleys by hand (Figure A).
3) Remove the screw holding the bearing to the pulley axle on the right side of the frame (Figures B & C).
FIGURE A FIGURE B
4) Turn the pulley until the hole in the pulley lines up with the screw in the frame. Then remove the first screw (Figure D).
FIGURE C FIGURE D
5) Turn the pulley until the hole in the pulley lines up with the screw in the frame. Then remove the second screw (Figure E).
6) Turn the pulley until the hole in the pulley lines up with the screw in the frame. Then remove the third screw (Figure F).
FIGURE E FIGURE F