38
CHAPTER 5: PART REPLACEMENT GUIDE
5.17 Pulley Axle (Secondary) Set Replacement – Continued
7) Install a screw into the secondary axle and turn the screw until the head is close to the secondary axle. Use a mallet to hit the screw until the pulley axle
assembly is loose in the frame and remove it (Figures G & H).
FIGURE G FIGURE H
8) Reverse Steps 1-7 to install a new pulley axle set.
NOTE:
The bearings on the pulley axle cannot be re-used after removal of the pulley axle assembly.
NOTE:
Clean the bearing frame housing and daub a fixative (Red Loctite 603 is recommended) on the inside of housing in the frame prior to installation
of a new pulley axle set (Figures I & J).
NOTE:
Torque the screw removed in Step 5 to 20 N-m.
\
FIGURE I FIGURE J
9) Test the bike for function as outlined in Section 5.20.
Please daub with
fixative (LT-603) on the
inside of housing.