X6200
Operation
Page 9
NOTE: Assembly Steps 9, 10 and 11 refer to Models X6200/ X6200HRC
only. For Model X6100 proceed to Step 12 for folding instructions.
Step 9 • Console -
Models X6200/ X6200HRC only.
1: Plug the Console Cable (108) into the Console (15). The cable
Connectors are slotted and will only fit properly one way. DO NOT
FORCE the connection.
2: Mount the Console (15) to the Console Mast (9) using the four
Console Attachment Bolts (162). Make sure you DO NOT PINCH the
Console Cable between the Console and the Console Mast.
3: Plug the Power Supply Cord (207) into the receptacle located at the
front of the Elliptical Trainer just above the Front Transport Wheels.
Plug the Power Supply (207) into an electrical outlet and begin testing
procedures.
NOTE: Always read the Owner’s Manual before operating your Vision
Fitness Elliptical Trainer.
Step 10 • Operation Test -
Models X6200/ X6200HRC only.
Run this simple optional test prior to using.
1: Choose Intervals program, Level 16.
2: Choose Time of “00:00”, and press Start.
3: Your machine will now operate indefinitely. After several hours of
operation, check for proper functioning of:
A: Resistance Change -- change load one level at a time using
the up and down arrows. Listen for motor noise (“whirr”)
following each change in load, or pedal to feel load change.
B: Check for display in RPMs while pedaling.
C: Check that all LEDs will light.
