Solstice Solo Series
Installation Instructions
Washington Warehouse
901 Algona Blvd N.
Unit F
Algona, Wa 98001
Ph: 888-489-9820
Fx: 253-218-2905
Arizona Warehouse
6501 E. Greenway
Suite 103-542
Scottsdale, Az 85254
Ph: 800-994-4460
Fx: 480-922-5655
www.visionxusa.com
Page 1 of 2
t
sche Connector
i-Link Connector
5. Allen
Wrench
ge Barrel Crimps or Soldering Iron, Solder and Heat Shrink
7. Included Allen Wrench
nter of the light. Make sure to
ector,
structions on the bottom of the next page before selecting
hole and tighten the nylock nut with a 10mm socket or wrench
f desired insert and
hand tighten adjustment set screws for use in high vibration scenarios.
WARNING!
– Only use included wiring to wire the
Solstice Solo Series. Even though the plug is the same as
other Vision X wiring, the Solo series has unique circuitry tha
can easily be damaged with wiring other than the included
pigtail.
Package Contents;
1. Solstice Solo Series Pod
2. Wiring Pigtail with Deut
3. Universal Stud Mount
4. Horizontal Omn
Required Tools;
1. ¼” Drill Bit
2. 10mm Socket and Ratchet
3. 10mm Open End Wrench
4. (2) 16 Gau
5. Crimper
6. Wire
Stripper
Mounting Instructions;
1. Drill ¼” Hole in desired mounting location.
a. Note – The center of your hole will be the exact ce
measure the location of your hole before drilling.
b. Note – If you are linking multiple pods together using the included Omni-Link conn
carefully read linking in
placement of mounts.
2. Insert stud mount through the ¼”
to a maximum torque of 20 ft/lb.
a. Note – DO NOT use air impact tool as they will damage the stainless threads.
3. Remove adjustment set screws if installed on adjustment bracket. Tighten the adjustment
nylock snug against the bracket and aim the light to desired position. After the light is aimed,
tighten the adjustment bolt and nylock to a maximum torque of 20 ft/lb. I
