Panel Assembly – Remaining Walls
Back wall
Locate and arrange the back wall panels from shortest to the highest
(peak) to create two separate half wall sections. Again, making sure
the DEEP Channel locks face out, join the panels together as with
previous assembly instructions. Insert into base track, joining the
section to the corner post you already attached to the corner of the
left side wall.
Repeat with the second half back wall, making sure first, to affix a
corner post to the back wall section. Join the second half back wall
with the first half wall.
Right side wall
Repeat assembly instructions, assembling and installing the
right side wall.
Right front wall
Finish the right front wall assembly.
7
Lintel and Front Header
Position the lintel into the door
opening resting it on the door frame
(Diagram 8A). While standing on a
ladder, fasten the lintel to the door
frame on each side of the opening
with the #8 x 1" pan head screws
provided (Diagram 8B).
With your assistant, insert the
preassembled front header section
into the lintel, joining the assembly
at the channel locks as with previous
wall sections and making sure the
panels are fully seated in the lintel
(Diagram 8C).
Once the front header is fully seated
within the lentil, secure the assembly
from inside the shed by installing the
#8 x 1" pan head screws (provided)
into the eleven (11) predrilled holes in
the lentil (Diagram 8D).
8
Slope Wall Caps
Position the aluminum slope wall cap on the left wall, lining up its ends
with the front and back wall. Press down to seat the slope wall cap
on the wall. Repeat for right side slope wall cap. It may be necessary
to stand on a ladder for this assembly step.
9
8A
8B
8C
8D
10
