Wall Vents
Locate the inner and outer vent covers for the two back wall
vents. The inner vent cover has a screw hole near the top
and bottom of the vent. The outer vent cover has no screw
holes. Position the outer vent covers into the vent openings.
Position the inner vent covers into the openings from inside
the shed. Insert screws into the screw holes through the inner
vent cover, engaging the outer vent cover. Tighten reasonably
snug. Do not overtighten.
17
Insert and Fasten Screws to the Interior Components
Insert #8 x 1" pan head screws
at the seams
(DRAWING) in all predrilled holes on the ridge beam, in the slope wall caps, fascia gables,
base tracks, lintel and roof fascia caps. Insert #8 x 1" screws into the door frame at the predrilled holes.
NOTE:
holes in exterior of Base
Channels are for drainage only. DO NOT INSTALL SCREWS IN THESE DRAINAGE HOLES.
IMPORTANT: Be sure to check door alignment several times during screw installation to ensure building has not moved out of
alignment. If it has, realign and resume installation of screws.
18
14
